ball cock การใช้

• NOTE : Drawing captioned " INSTALLING A NEW FLOATING-CUP BALL COCK " goes with this column.
• As for the other leak, it sounds as if the ball cock, is worn and should be replaced.
• Atop its dome, whose three 16-sided tiers are trimmed in Victorian gingerbread, is a spire that terminates in a copper toilet ball cock.
• Lift out this entire unit, with its attached float ball and arm, and install a new cup-type ball cock in its place, following the directions supplied.
• :: : There is generally a little plastic nut and bolt at the end of the ball cock arm that controls how far it can rise.
• A : Some brands of ball cock are much quieter than others, so it is possible that by installing a different model you will eliminate this nuisance.
• The ball cock is the shut-off valve in the tank that is supposed to be closing as the water reaches the top of the tank, but isn't.
• A friend told me that I ought to modernize this tank by removing the old ball cock valve and other parts, and then install new, modern components.
• In most cases you can solve this problem by replacing the old ball cock with a more efficient new model ( these are sold in all hardware stores and plumbing outlets ).
• A : From your description it sounds as though the noise is being caused by a dirty ball cock inside the flush tank ( the ball cock is the inlet valve mechanism ).
• A : From your description it sounds as though the noise is being caused by a dirty ball cock inside the flush tank ( the ball cock is the inlet valve mechanism ).
• Then disconnect the water line leading from the shutoff valve to the bottom of the tank and unscrew the large nut under the tank that holds the ball cock in place on the inside.
• :: : : : It is a water tank, usually in the loft, with a ball cock, fed by mains water supply and supplying water to wash basins, baths, showers and toilets in the house by gravity feed.
• Q : Ever since I installed a new ball cock inlet valve unit in my toilet flush tank we notice that just before the tank is full and the inlet valve shuts off, it makes a loud hissing noise.
• In January 1916, the Engel Manufacturing Company advertised the Engel Ball Cock " because it has been giving absolute satisfaction in actual service for the past ten years . " It was made of the highest grade metal with hardware bronze seat and was the only ball cock produced with adjustable refill tube and was designed to " work equally well on high or low pressures ."
• In January 1916, the Engel Manufacturing Company advertised the Engel Ball Cock " because it has been giving absolute satisfaction in actual service for the past ten years . " It was made of the highest grade metal with hardware bronze seat and was the only ball cock produced with adjustable refill tube and was designed to " work equally well on high or low pressures ."